The Geodesic domes are spherical in shape were lightweight triangular or polygonal facets consisting of either skeletal struts or flat planes, largely in tension, replace the arch principle and distribute stresses within the structure itself.
There are probably as many different dome designs as there are dome builders. This is partly because size, geometry, designs and coverings can be modified according to the raw materials available. The design shown here, though not as grand as the ones developed by experts, still uses the same basic geometric form. It is simple to build and easy to dismantle.
Depending on the type of covering you use, this design is suitable as a temporary or semi-permanent dwelling.
The essentials:
To build your own dome home you will need the following:
• Time : about a day (although it will only take about an hour to put up and less to take down).
• Equipment : drill and drill bits, tape measure, protractor, hand saw and a vice (not essential but will make construction more accurate, particularly when drilling the holes).
• Materials : hazel poles or broomsticks, about 20mm (¾") in diameter, 1.5m (5') of 130mm (5") alcathene gas pipe and 260 split pins. These make it easy to erect and take down your dome.
Preparation
Step 1. Cut 35 poles to exactly the same length: 1050mm-1200mm (3'6"-4') would give even tall people adequate headroom. Do not cut them shorter than 900mm (3') unless building for children; and 1200mm (4') is probably the optimum length for the strength of materials and joints used in this design.
Step 2. Saw 30 more poles, which must be 11% shorter than the long poles. For example, if you cut the long poles to 1200mm (4') then your shorter poles will be 1070mm (3'6").
Step 3. Cut the alcathene gas pipe into sections 50mm (2") long to make the joints. You will need 26 joints in all.
Now you need to drill holes in the joints to hold the ends of the poles. The holes will need to be fractionally larger than the poles you use. For example, if you use standard household broomsticks which are roughly 20mm (¾") thick, holes will be cut to just less than 25mm (1") in diameter. This will ensure enough 'give' in the joints to create the angles necessary in dome building. You must make precise measurements. Be consistent, regardless of the dimensions you decide upon.
Assembly
Step 1. Assembling a prototype:Take one 5-hole joint and slot in five of the smaller poles.
Put two 4-hole joints at the base of the pentagon and slot three 6-hole joints onto the upright poles.
Step 2. At this point, measure where the holes need to be drilled in the poles either side of the pipe. Depending on the thickness of the pipe, this will be about 25mm (1") from the end of each pole and again about 25mm (1") further along the pole.
Once you have marked the poles, dismantle the pentagon. Sort the poles into two piles – long and short. Drill two holes in each end of every pole. It is vital that each hole is drilled in exactly the same position on every pole.
Step 3. Reassemble the pentagon and fasten the joints by inserting the split pins. Build from the middle outwards following the pattern as shown in video.
You can view the video in this post. Geodesic dome home was built in Aranya eco village, Berikai, Tamilnadu.
Mango people an organization who helped in building Geodesic dome.
Video courtesy : #mangopeople #aranyaecovillage
You can learn how to build geodesic domes practically through Auroville Bamboo centre.. The courses are going on.. :)
You can also contact #mangopeople an NGO in faridabad.
#geodesicdomes #portableshelters, #bambooshelter
0 comments:
Post a Comment